The edge inspection vibration knife integrated machine is a common processing equipment, and its common faults include:

1. Incomplete cutting or whitening of the incision: This may be due to the lack of melting of the carbide structure. You can try increasing the power of the heating element or raising the temperature of the barrel to solve this problem.

2. Residual aluminum slag on the workbench: This indicates that the molybdenum wire was not pressed properly during mechanical feeding, which may result in virtual movement or excessive sparks causing unstable cutting. It is necessary to check and adjust the position of each part of the machine to ensure a stable working condition.

3. Water and oil leakage at the machine head: This situation may require personnel to investigate and repair to maintain the normal operation of the equipment.

4. No air output or sparks: This may be due to clogged air filters or damaged ignition devices, and it is necessary to clean or replace the corresponding components in a timely manner.

5. Other non recurring faults such as poor line contact may also affect the overall performance of the mirror system

Please note that these are just some common problems and solutions that may arise, and the specific situation needs to be judged and handled according to the actual situation. Technical knowledge should be consulted before dealing with any potential issues to avoid more serious damage caused by improper operation.